Jump to content

Lichfield Wanderer Tent Instructions


Guest Jenny

Recommended Posts

I found them! After I had worked it out without them! condensed they are:- 1.You will have three short upright poles,one longer upright pole and a ridge pole, each of which will comprise several sections. 2. Peg out the corners of the inner groundsheet using the small pegs through the corner pegging points. 3. From inside the inner stand the longer upright up with the spike passing through eyelet and the foot on the groundplate. Repeat with one of the shorter uprights at the back of inner. 4. Place spacer tubes on the two protruding spikes.Thread the ridge pole through the loop ( which is at the middle of the ridge of the inner) and then position the the ridge ends onto the spikes of the uprights. 5. Peg out the inner tent walls. 6. Place flysheet over inner positioning the eyelets over the spikes. Place two raincowls over the spikes. 7. Peg out the flysheet well away from the walls of the inner tent, start adjacent to the front of the inner working towards the rear then towards the front. Drive the pegs into the ground at an angle and ensure that the canvas is taut and the tensioners slightly stretched. 8.The two remaining uprights stand at the front of the living area with the spikes protruding through eyelets. Put two rain cowls over the spikes then attach the guylines which should be pegged out towards the front and tensioned firmly. 9. Attach the shorter guylines to the eyelet patches on each side of the flysheet and lightly tension to prevent the flysheet blowing into the inner.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...