Donald Trumps Hair Posted May 24, 2018 Share Posted May 24, 2018 Good day all I am new to the forum so please go easy on me!! I have 2 reverse cameras on my Elddis autoquest 140, the one below the number plate works fine but the high level one is showing “no signal on the monitor, I know it is powered because the Nighttime LEDS light up when it’s dark, the wiring is all run through the inside of the unit (not fitted by me) and I am loathe to start stripping stuff out to trace it. I put a new camera on to check it wasn’t the camera, lit up ok still no picture. I am at my wits end. Any suggestions I might try before handing hard earned money over to an auto spark or motorhome specialist would be massively appreciated Thanks Link to comment Share on other sites More sharing options...
jobboyce Posted May 24, 2018 Share Posted May 24, 2018 Hello, have you tried swapping the top camera connection to the monitor withe the bottom one (you may have a damaged cable. Can you access the monitor menu and swap the cameras in there? Also it could be a fault within the monitor. Good luck Robert :-D Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.