Bob R

My next move is to use a meter and connectivity test all the cct from the connector to the screws inside the tank also clean all the connections under the screw heads. I just need to find the other three screws !

Thanks chaps I’ve found the 5 way connector so I’ll just race the other wires to the remaining sensors, when replacing the screws is it just a case of unscrewing them and replacing with new screws. I assume that there’s nothing inside the tank that needs to be held whilst unscrewing from the outside!

Hi I was underneath yesterday and all I could find was what appears to be two screws through the side of the tank one near the top and one about six inches down from that, they have wires going to the outside under the head of the screws! Seems pretty basic to me hence my post in case I was missing something else, I’ve removed the tank end cap and cleaned the threaded bit inside but the alarm still sounded. Is there anything else I need or can do !

Sargent EC155

Hi thanks for the reply Ive had a look through the handbook but can’t find any info on recalibration after cleaning! Bob

Hi Im experiencing problems with my alarm on the cold water level alarm which seems to have a mind of its own. I’ve tried tank cleaner, I’ve had the end cap off the tank but can only find to two what feels like threaded screws on the inside with wires under tape going to each of the screws on the outside of the tank. They vehicle is as above 2017 model, does anyone know where the actual sensor is ! TIA